Configuration Help
Need help with the Configuration Panel of LUCID?
8. TouchOSC Zeroconf Name.
This Name is very important since it will help the Host find your Controller on the Network automatically. If you wish to change the name of your TouchOSC device change it here and in the Zeroconf/Custom side of the TouchOSC application.
In Manual Mode, you'll have to find by yourself the IP of the TouchOSC device (Client), and enter it here. Tips: you can click the little ⓘ button next to the "Receive Port" in TouchOSC (inside the OSC connection panel) to see the available IP addresses. (You can exclude the IPv6 for this)
9. Network Port-Out.
This is Port on which the Host will send the information to display to the Client. If you change this Port make sure to also change it on the receiving end, in the TouchOSC application inside the OSC Connection Panel under the "Receive Port" (Default is 9001)
10. Refresh Button.
Use this button after finishing the configuration to check the connection and restart the remote if it wasn't already detected on launch.
1. Open and Close the Config Panel.
Open and Close the Config Panel, in the Host device. Not much else to day.
2. Open this page.
You are on this page, so you probably already clicked this button!
3. Zeroconf / Manual Toggle.
This button allows you to switch from Zeroconf to manual mode.
In Zeroconf, the remote will try to find and assign IP addresses as well as Ports automatically based on the name of the devices on the network.
In Manual you'll have to set IP addresses and Ports manually on both sides. (More info per-option below)
4. OSC Input Activity.
This monitoring LED, is there to show if there are any incoming messages.
5. The name of your computer on the network.
This helps to find the IP address of your computer from the TouchOSC application, from the OSC connection panel directly. By default, it will take your computer's username.
In Manual Mode, this will be up to you to find what is the IP address of the correct network interface accessible to your computer, and enter it manually inside the TouchOSC application.
6. Network Port-In.
This is the entry point of messages sent by the Client. If you change this Port make sure to also change the "Send Port" inside TouchOSC as well. (Default is 9000)
7. OSC Output Activity.
This monitoring LED shows OSC message output activity from the Host.
